Spring temperatures gradually rise, air humidity has also changed, for nylon thermal fuse manufacturers, the correct way of preservation is crucial, the following are some points to save nylon thermal fuse in the spring:

Warehouse environment requirements

Temperature control: Nylon thermal fuse is more sensitive to temperature, spring temperature fluctuation is large, should try to keep the warehouse temperature between 15℃-25℃. High temperature may cause the hot fuse to become soft and cohesive, affecting its performance and use. Too low a temperature may make the hot fuse brittle, increasing the risk of fracture.

Humidity control: Spring air humidity is usually high, and nylon thermal fuse is easy to absorb moisture, too much moisture will affect its hot melt effect and mechanical properties. Therefore, the relative humidity of the warehouse should be controlled at 40%-60%. Humidity can be adjusted by using a dehumidifier, such as a dehumidifier, or by placing desiccant in the warehouse.

Ventilation conditions: Maintain good ventilation of the warehouse, which helps to adjust temperature and humidity, but also to avoid odors or harmful gases caused by poor air circulation, affecting the quality of the hot fuse. However, be careful to avoid placing the thermal fuse directly at the vent to prevent dust and impurities from attaching.

Packing requirement

Preservation of the original package: Nylon thermal fuse usually has a sealed original package when leaving the factory, and the original package should be kept intact as far as possible to avoid opening at will. The original package provides certain protection against moisture, dust and oxidation.

Secondary packaging protection: For the packaging that has been opened, the remaining hot fuse should be secondary packaging. It can be sealed with a ziploc bag or plastic film to prevent air and moisture from entering. At the same time, indicate product specifications, models, production dates and other information on the packaging to facilitate management and traceability.

Storage mode

Shelf storage: The nylon thermal fuse is stored on the shelf to avoid being placed directly on the ground to prevent ground moisture erosion. Shelves should be kept clean, dry and easily accessible. Hot fuses of different specifications and models should be stored in categories and labeled for quick search.

Avoid extrusion: Nylon thermal fuse should avoid being squeezed when stored to avoid deformation or damage. If it is a coil, pay attention to the stacking height, do not exceed the specified number of layers, to prevent the bottom of the coil compression deformation.

Periodic inspection

Appearance inspection: Regularly check the appearance of the nylon hot fuse in stock to see if there are discoloration, moisture, caking and other phenomena. If any anomaly is found, it should be handled in time to prevent the problem from expanding.

Performance testing: Every once in a while, the performance of the hot fuse is tested, such as melting point, viscosity, tensile strength, etc., to ensure that its performance meets the quality standards. For long-term inventory of hot fuses, a comprehensive performance test should be carried out before use.

Through the above preservation methods, the quality and performance of nylon thermal fuse in the spring can be effectively guaranteed, the loss caused by improper preservation can be reduced, and a stable supply of raw materials can be provided for production.

Fujian ZhangpingXielong Group High-tech Chemical Fiber Company Co., Ltd. leading products of include：nylon thermal fuse, TPU special filament, polyester thermal fuse, TPU hot melt omentum, PA hot melt omentum,.The company has always adhered to the 3s core service tenet: "saving time, cost savings, saving losses", advocates a total of industrial value, and is committed to providing a better solution for the overall industrial chain. Plan, welcome to buy the nylon thermal fuse，polyester thermal fuse!